🦀 Citroen C3 1.4 Hdi Starter Motor Removal

The fault code P1351 comes back straight away after it is cleared. Pins 7,6,2,3, all have 12.6v from the wiring harness relay, so I think I pulled out the glow plugs for nothing, as I thought pins 7,6,2,1 were the glow plugs. The actuator test for the relay works (I can hear clicking). Can anyone help with a wiring diagram for the relay harness

Remove glow plugs to ease turning engine. Turn engine in normal direction of rotation (unless otherwise stated). DO NOT turn engine via camshaft or other sprockets. Observe all tightening torques. How to Replace timing belt on Citroen C3 1.6 HDi 2009-.

^{(10A) Engine coolant ‘low’ sensor, automatic transmission (AT), engine control module (ECM), engine coolant heater relays, power steering control module, cruise control, brake pedal position (BPP) switch: 5 (10A) Fuel additive control module: 6 (15A) Front fog lamps: 7 (20A) Headlamp washer pump: 8 (20A) Engine management: 9 (15A) LH}

Consider to support my channel and all the hard work put into it at http://www.patreon.com/LMAutoRepairsThank youHiThis car came to me in limp mode, the engi

Its a 2008 1.4 16 valve engine code EP3 8FS. Long story short, we had to fit a second hand engine as the timing chain tensioner had come lose and a compression test showed low compression on cylinder one. New engine has been fitted and timed up but thrown up two fault codes P0014 and P11A8. I've swapped over the Exhaust solenoid from the old . 127 221 142 186 123 401 242 453

citroen c3 1.4 hdi starter motor removal